Steering knuckle

Ići dole

Steering knuckle

Počalji od heviarti taj Uto 06 Feb 2018, 19:36

I just got another front end alignment yesterday after replacing the right control arm on Friday. Everything was about right on the left side before the alignment, and replacing the other control arm fixed all the problems on the right side. Now my camber is wrong on the left. We are suspecting that the arm on the steering knuckle where the tie rod end attaches may be bent. The aligning rack reads everything as right except the camber, and we have no thread left on the right tie rod end, but about a half an inch on the left with the toe set. Is there a way to check these? I have two or three manuals, but nothing really goes deeply into checking or aligning the front end. If the level of wear on the tires stays the same on the left side, I should be OK for a while.
Sorry if I am duplicating a topic, Google translate is acting strange lately. Sometimes it translates a thread, and sometimes not.
avatar
heviarti
OHV 767ccm 30ks

Broj poruka : 148
Godina : 39
Lokacija : Emmett, Idaho USA
Datum upisa : 11.06.2017

Pogledaj profil korisnika

Nazad na vrh Ići dole

Re: Steering knuckle

Počalji od junior45 taj Uto 06 Feb 2018, 20:07

Is control arms same lenght?maybe you have one control arm from florida,one from yugo
avatar
junior45
KLJUGI

Broj poruka : 25052
Godina : 27
Lokacija : Farkazdin-Zrenjanin
Datum upisa : 10.01.2012

Pogledaj profil korisnika

Nazad na vrh Ići dole

Nazad na vrh


 
Dozvole ovog foruma:
Ne možete odgovarati na teme u ovom forumu